Bosch ev14 550cc Fuel Injectors with plug and play adapters to suit OBD2 Honda/Acura Engines
 
Looking to upgrade injectors without breaking the bank? Listing is for a set of Bosch ev14 550cc fuel injectors to suit OBD2 Honda/Acura engine. Perfect for the budget builder looking for rock solid reliability and superb performance for an excellent price. For the added piece of mind we cover our injectors for 2 years with our unlimited mile warranty. PLEASE VIEW VEHICLE COMPATIBILITY GUIDE BELOW. Injectors are high impedance so no resistor box/injector drivers necessary. If your vehicle is fitted with a factory resistor box then it must be removed. Listing includes plug and play injector adapters to allow the to plug right into the factory OBD2 injector harness. No cutting or soldering wires necessary.
 
The injectors are compatible with all known fuels including e85. The injectors retains a consistent linear flow from 3bar to 7 bar fuel pressure. Very tuner friendly with fuel trimming down to 1.0ms. The injectors will support over 350whp with correct tuning and fuel type. The injectors utilize single 30 degree mist spray pattern with excellent fuel atomization resulting in superb idle conditions. Injectors are dynamically and statically flow tested on the industry leading ASNU Classic test equipment. They are then sealed and packed in balanced sets within 1 percent.  Injectors will come with flow sheet with full data specs including injector latency/dead time data for easy tuning. 
 
INJECTOR FEATURES:
Flow Matched Sets within ≤ 1% Static and Dynamic flow rates
Full Injector Latency Data Provided
Tunable to factory Rock solid Idle
Excellent Fuel Atomization
Direct Plug and Play Fit
Fast Response time
Consistent performance all the way to 100psi+ Fuel Pressures
2 Year Unlimited Mile Warranty
Stainless Steel Internals 
Compatible with all known race fuels including E85
Vehicle Compatibility Guide:
- 1996-2000 CIVIC/DEL SOL (ALL TRIMS)
- 1996-2000 INTEGRA (ALL TRIMS)
- 1997+ PRELUDE (ALL TRIMS)
- 1996 + ACCORD 4 cylinder (ALL TRIMS)
- Will Also fit all OBD0 & OBD1 JDM engines!
 
INJECTOR SPECS:
Static Flow Rate (gasoline) @ 43.5PSI (300kPa): 550cc/mi
Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Spray Pattern: Wide 30 degree mist (single orifice)
Electrical Connector: USCAR
Fitted with Viton o-rings
Includes lower to injector seal.