Clean Injection Performance Bosch Series injectors are Bosch Motorsport base injectors. Designed to suit 1JZ/2JZ engine with Radium Engineering fuel rail setup. Injectors will also come with plug-and-play connector adapters which allow the injectors to plug right into the factory injector harness. (Select the Injector flow rate needed. Injector sizes from 550cc 650cc 750cc 850cc 1000cc, 1200cc available)
Clean Injection Performance Bosch ev14 series injectors have full stainless steel internationals making it compatible with all known fuels including e85. The injectors retains a consistent linear flow from 2bar to 7bar fuel pressure. Very tuner friendly with fuel trimming down to 1ms. Every set of Injectors that leaves Clean Injection goes through extensive testing on industry leading ASNU Classic test equipment. Every set is flow tested statically, dynamically, and packed in balanced sets within 1 percent. Injectors will come with flow sheet with full data specs including injector latency/dead time data to make tuning breeze.
INJECTOR FEATURES:
Flow Matched Sets within ≤ 1% Static and Dynamic flow rates
Full Injector Latency Data Provided
Tunable to factory Rock solid Idle
Excellent Fuel Atomization
Direct Plug and Play Fit
Fast Response time
Consistent performance all the way to 7 BAR
2 Year Unlimited Mile Warranty
Stainless Steel Internals
Compatible with all known race fuels including E85
Vehicle Compatibility Guide:
- Fits Toyota 1JZ/2JZ with Radium Engineering Fuel Rail Kit
INJECTOR SPECS:
Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers) Spray Pattern: Wide 30 degree mist (single orifice) Electrical Connector: USCAR Fitted with Viton o-rings
48MM height with 14mm top and bottom orings
LISTING INCLUDE:
6pcs Clean Injection Performance Bosch SERIES EV14 fuel injectors
6pcs Plug and Play injector connectors















